ISECO Refrigeration Engineering ← Back to home
Analysis

CFD & Thermal Analysis

Thermal scanning shows where a plant is losing performance today. CFD shows how air and temperature will behave in a room before it is built or changed. Together they take the guesswork out of cold room, plant room and ventilation decisions.

Thermal
Scanning

A fast, non-invasive survey of an operating plant. Temperature differences that are invisible to the eye show up clearly on a thermal camera.

What it can find

  • Hot spots on motors, switchboards and electrical connections
  • Insulation gaps, damaged panels and cold bridges
  • Warm air leaking through doors, seals and penetrations
  • Uneven frost or temperature on coils and pipework

What you receive

  • Annotated thermal images with measured temperatures
  • A ranked list of issues by severity
  • Recommended repairs and where to start
Thermal scan — plant room panel
Thermal scan — plant room panel
Computational
Fluid Dynamics

CFD builds a 3D model of a room and its equipment, then calculates how air moves and how temperature and humidity spread through the space.

What it can show

  • Airflow patterns around evaporators, ducts and racking
  • Temperature uniformity across a cold room or product area
  • Relative humidity distribution and condensation risk
  • Heat flow through floors, slabs and thermal bridges
  • Ventilation and purge performance in plant rooms

When it is worth doing

  • New cold rooms or plant rooms, before layout is fixed
  • Rooms with warm spots, poor product temperatures or frost build-up
  • Comparing options such as coil position or duct arrangement
  • Checking ventilation against safety and code requirements
CFD model — plant room ductwork
CFD model — plant room ductwork
CFD — relative humidity distribution
CFD — relative humidity distribution
CFD — steel beam thermal bridge through a −20 °C cold room floor
CFD — steel beam thermal bridge through a −20 °C cold room floor
Model
Coordination

Analysis is more useful when it uses the same geometry the project is built from.

Revit and BIM

  • Analysis models built from, or checked against, the Revit design
  • Clashes between pipework, ducts and equipment found early
  • Results fed back into the layout, not left in a report
Revit coordination model
Revit coordination model
How an
Engagement Runs

The same five steps apply whether it is a half-day scan or a full room model.

  1. BriefWe agree the question, the room and what a good result looks like.
  2. Survey or modelSite scan and measurements, or a 3D model built from drawings.
  3. AnalyseThermal images assessed, or the CFD simulation run and checked.
  4. ReportClear images, plots and findings written for engineers and operators.
  5. RecommendPractical changes, ranked, with the option of re-testing afterwards.
Have a room that will not hold temperature, or a plant room layout to test? Get in touch.

Need a closer look at your plant?

Contact ISECO